八八字典>英语词典>load characteristic curve翻译和用法

load characteristic curve

英 [ləʊd ˌkærəktəˈrɪstɪk kɜːv]

美 [loʊd ˌkærəktəˈrɪstɪk kɜːrv]

网络  负载特征曲线; 负载特性曲线

电力

双语例句

  • Therefore, an analytical method for unbalanced magnetic pull taking advantages of the no load characteristic curve of a generator is proposed.
    为此,提出了利用发电机空载特性曲线分析计算不平衡磁拉力的方法。
  • Using PRO/ E for drilling institutions carry through dynamic load simulation and modal analysis, obtaining its kinematics and dynamics characteristic curve, the vibration characteristics, weak links and its improvements opinion.
    利用PRO/E对钻具进行运动仿真和钻头的头体模态分析,获得其运动学、动力学特性曲线、振型特征、薄弱环节及改进意见。
  • The motors 'load characteristic curve is one of the main characteristic curves.
    发动机负荷特性曲线是发动机主要特性曲线之一。
  • This article analyzes the load characteristic curve of fans and expatiates the virtue of hydro-viscous speed governing clutch used in speed governing running with variable flow of the fan. The result testifies that the speed method possesses energy saving effect.
    本文通过分析通风机的负载特性曲线,阐述了液粘调速离合器在通风机变流量调速运行中的优点,计算结果表明,采用这种方法具有节能效果。
  • Result analysis of dead load experiment on static pressure precast pile of nine small section in three buildings indicates that Q-s curve of precast pile friction type takes on characteristic of double curve.
    通过某小区三幢住宅楼9根小截面静压预制桩静载试验成果分析,表明以侧阻力为主的摩擦型预制桩Q-s曲线呈双曲线的特征。
  • This paper studies the classification based on load after load characteristic curve of the loss calculation method, the line into each load the actual load characteristic curve value, effectively improve the theoretical loss calculation precision. 4.
    本文研究了基于负荷分类后的负荷特性曲线进行线损计算的方法,将各负荷线路带入其实际的负荷特性曲线值,有效提高了理论线损计算的精确度。
  • To perform comprehensive economic management and allocation for load and fuel between various units, the load and BFG should be considered. So univariate coal characteristic curve cannot be applied in solving target problem.
    本论文针对以上多种类型、燃用多种燃料的机组进行综合经济管理和负荷、燃料合理分配,由于必须同时考虑负荷和高炉煤气的合理分配,所以使用单变量的煤耗特性曲线无法解决目标问题。
  • Frequency control equation is established based on the analysis of load mechanical characteristic, stepper motor torque-frequency characteristic, systemic motion equation. Frequency control curve is drawn by MATLAB software.
    在分析负载的机械特性、步进电动机的矩频特性、系统的运动方程式的基础上,建立频率控制方程,并运用MATLAB软件绘制控制曲线。
  • Discussion on How to Forecast Gross Load from Component Loads Using Load Characteristic Curve
    应用负荷特性曲线由分量预测总量负荷的方法研究
  • Design of a diaphragm spring for automotive clutch is principally aimed at the determination of various structural parameters to obtain an ideal load& deformation characteristic curve which is in accordance with the requirements of the vehicle.
    汽车离合器膜片弹簧设计的主要任务,是确定各结构参数,以获得理想的载荷&变形特性曲线,并使其符合实车布置条件的要求。